Now onto the interesting part, I wanted to do something with the motherboard due to the cables that would be on show in the tower 900 so I decided to custom make and print some covers to hide these.
First off I done a couple of test prints for this to cover the sides, this was followed by a bottom section to cover the sata ports and the others (in tower 900 the board is at 90 degrees so the bottom is where mobo power is now).
So test prints were ok and what I had planned, so time to add some skulls to the reservoir, here is what I came up with.
First test print was not that great as the skull did not go over the top of the res, but easily corrected as you will see later, so moving onto the gpu block.
Now the gpu block covers were done, I would have to add something as I needed a sli bridge and what better way that to print something that tied into the tattoo flash theme than this.
I also wanted to do a custom fan grill too as one fan is clearly visible in the tower 900.
Next after doing the majority of the printing, I wanted to add something to the windows here is what I went with on the two side windows.
The Left side window I went for a dragon design, while the right side window was a…
Pheonix, onto the front window and I had a simple design that ended up adding more on the sides there was these
And ill leave the final pics of the middle section until next post which will be final ones.