Cutting your rigid PETG tubing can sometimes be a pain as you can never get a nice straight cut. Seems like you can try your hardest, but it is never quite flat. If you do get it cut right, then you have to use a tool to clean up the edge and the use sandpaper the edge to get a smooth tapered edge so you don’t cut one of the o-rings in the fitting. The Primochill RFB (Rigid Finishing Bit) can take care of all of the about in just a few seconds. With a standard hand drill, you can take 15 minutes of work down to just 15 seconds. You can also use the Primochill Rigid Finishing Bit – RFB – to trim down the length of the tubing to get that perfect fit.
- Size: 1/2in. ID x 5/8 in. OD (12mm ID x 16mm OD or 13mm ID x 16mm OD)
- Small tool easily stored
- Designed to Fit Standard Drills
- Sealed Bearings That Allow for Scuff-Free Spinning
- Designed to Fit Standard Drills
- Sealed Bearings That Allow for Scuff-Free Spinning
- Material: PETG, PMMA (Due to extremely quick dulling of the bit, Copper tubing is not recommended.)
- Practice using the RFB on some scrap rigid or cut longer than needed until you get the hang of how fast or slow the bit will remove material.
▶ Get your very own Rigid Finishing Bit at https://amzn.to/2D7VoE1
▶ AMAZON Check out our page for recommendations
https://amazon.com/shop/moddersinc
▶ FOLLOW US
Facebook – https://www.facebook.com/ModdersInc/
Twitter – https://twitter.com/moddersinc
Instagram – https://instagram.com/moddersinc
Twitch – https://twitch.tv/moddersinc
▶ Help us help you with more videos. Be a member of Modders Inc by being a Patron. https://www.patreon.com/moddersinc
#casemods
#hardwarereviews
#buildingpc
