I then set out the LEDs in the mouse and assembled them on the poor man's solder jig, then to shrink tube, clear coated the bare leads, and hook it to the mouse power.
The only spot to solder was a tight solder on the connector's pins. A test before final assembly. power came from a KVM switch.
Final photos done and working…
This guide is for informative purposes only! We (Modders-Inc.) will not be held responsible for any damages caused to or resulting from anything that you have decide to do to your case or hardware. We (Modders-Inc.) will not be held responsible for injury to your person or others as a result of you or others attempting any of the things that are shown on this site. You are responsible for your own actions, whether your actions are based on information gathered from Modder-Inc or its affiliates. Always use the proper tools for a job. Always wear the necessary Safety Equipment.