After pushing it in a couple inches go back and check that both sides of the strip are locked in. Then move on a couple more inches, repeat this until done. Tedious but necessary.
Pushing in the lock strip with a finger
Remove the rest of the protective film and clean off the finger prints to finish this mod off.
Finished panel ready to go on a case
Install the panel back onto the computer and enjoy the fruits of your labor.
Guide Written By Krystal.
This guide is for informative purposes only! We (Modders-Inc.) will not be held responsible for any damages caused to or resulting from anything that you have decide to do to your case or hardware. We (Modders-Inc.) will not be held responsible for injury to your person or others as a result of you or others attempting any of the things that are shown on this site. You are responsible for your own actions, whether your actions are based on information gathered from Modder-Inc or its affiliates. Always use the proper tools for a job. Always wear the necessary Safety Equipment.